The upcoming 0.6 release will be the first to include it. If not, we may have to add your board's DMI information to a list somewhere. If you run OpenRGB as administrator it should be able to detect MSI-RGB. This doesn't use USB at all, it uses the Super IO chip. The released OpenRGB builds don't support Mystic Light boards right now. Older MSI boards use a completely different RGB system that we call MSI-RGB. Get the latest development pipeline build of OpenRGB (which includes the tested Mystic Light boards) here: You will need a ~$25 programming adapter to do this. If you did happen to brick your board's RGB controller, either by using an old or development build of OpenRGB or somehow via Dragon Center/Mystic Light, I can also walk you through the steps to un-brick your RGB chip. I would like to verify your board's packet size before you test this build for safety reasons. If you have such a board, contact me on the OpenRGB Discord or via private message and I will walk you through the steps needed to verify your packet size (capturing packets from the official MSI Dragon Center) and then send you a link to a build with all the boards enabled. I've also enabled one USB ID for the older generation 162-byte Mystic Light chip which I have on my B450 Pro Carbon Wifi and this one has been thoroughly tested as well.įor untested boards there is currently no bricking risk either, but the Mystic Light code remains disabled so you will not be able to control these boards. I've only enabled the USB IDs of boards that have been verified to work for now. I then opened it up for testing on the OpenRGB GitLab and Discord and others have also had success. I recently purchased an MSI MPG X570 Gaming Pro Carbon Wifi motherboard to test OpenRGB on to ensure the bricking issue was resolved, and after putting it through a lot of fast writes and testing all the available modes (of which only a subset are currently enabled), the board has remained fully functional with no bricking issues. A bug was identified where the code was only sending 184 bytes rather than the correct 185, which seemed to be the culprit of the bricking issues. I'm happy to report that this is no longer the case. I recently re-enabled the Mystic Light motherboard support in OpenRGB! The support was added early last year but was quickly disabled because it caused some RGB chips to brick.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |